1. Get Started
1.1
Assembly
1.2
Battery Care Tips
1.3
Unfolding the Element Pro
Connecting the Handlebar:
• Connect the four plugs according to color. Make sure the plugs clip in
correctly. If you have any issues with the wires, please contact Jetson
Customer Support. Tuck any excess wire into the Stem Tube.
• Slide the Handlebar into the Stem Tube.
• Tighten using the four screws. Make sure the screws are tight and
the Handlebar is secure.
- Charging
- Charge Complete
Charging Port
Unclip
Connect
Screws
Lift Handlebars away from Deck.
Unclip the hook from the
Rear Foot Brake.
• Only use the included charger.
• Plug the charger into the wall before the Charging Port.
• Don’t turn on the Element Pro while it’s charging.
• Charge the battery until it is fully charged - up to 4 hours.
• Replace the cover over the Charging Port when done.
CHARGING INDICATOR ON THE CHARGER:
Charging Temperature: 320 ~ 1040F
Operating Temperature: 320 ~ 1040F
Note:
Tighten all screws and locking nuts before each ride to ensure
they are tight.
Warning:
Failure to properly connect the plugs may cause the wires to
smoke and other damages not covered by warranty.
