Jetmaster INSET, Инструкции по установке, эксплуатации и обслуживанию

Страница: 17 / 6295

Bottom V Board Removal
First remove the bottom V boards by gently lifting them up at the front edge. Care should be taken with the
thin sections that surround the cast bottom grate so they do not break.
Rear V Board Removal
Remove the rear left and right vertical V boards by gently pulling one edge out first, then slide forward. Note they
are handed with a cut out in the corners.
Side V Board Removal
The left and right side V boards can be removed by gently pulling one edge out first then, slide the boards
towards the centre of the fire.
To replace the V boards offer one edge in first and then push the V board gently back.
Note:-­ They should be pushed back flat against the steel body of the fire.
Note:-­ Some of the V boards will only fit one way around and if they are forced will break.
Flue Adaptor Removal (If fitted to fire)
With the internal components removed it is now possible to get to the flue adaptor bolts. These should be
removed and the adaptor carefully removed from the top of the fire. Take care not to damage the adaptor seal.
If some of the internal V boards are still in situ then care should be taken when removing and replacing the flue
adaptor bolts so that none of the internal parts become damaged.
Inner Firebox “Engine” Removal
Finally with the adaptor removed the inner firebox engine can be removed.
Slide the inner firebox “engine” out on the guides from the outer box. The engine contains easy grip areas that
allow 2 people to easily lift it out. With the inner and outer boxes now separate work can begin to fit the outer
firebox into the prepared opening.
Fitting the Firebox
Due to the modular construction of the unit, you can for instance:
Fit the flue adaptor, air supply pipe and the outer box. The rest of the components can be kept in safe storage
while all rough building and finishing work is being completed. At the final stage, the engine and finishing frame
can be fitted.
This way there is less chance of aesthetic damage, or accidental damage to important components while building
work is in process.
Flue Adaptor Connection to Flue
The flue adaptor can now be attached to the base of the flue liner. This can then be pushed up while the outer
firebox and inner fire box are slid into place. After the fire is installed then, working from the inside it should be
possible to pull the adaptor together with the liner downwards into the recess at the top of the inner firebox. Once
it has seated correctly then the 3 bolts must be screwed into the nut fixings to hold it in place.
If an existing rigid flue is to be used and is suitable then the adaptor will need to be joined directly to the flue.
The opening will need to be prepared high enough to allow the outer box adaptor and any flue pipe to be slid in
place and with sufficient room to work to enable connection between fire and flue.
This may involve breaking into the front of the chimney breast to create sufficient space.
17