JetCat P100-RX, Руководство пользователя

Страница: 24 / 54

PAGE 24 of 54
The GSU screen will display:
 Throttle channel “
Idle
” position
5.
Advance the throttle trim lever to maximum. Press Select Menu or the LED I/O board button switch
again
to store the R/C system’s pulse width for the turbine idle position. The red
Pump running
LED will turn off and the yellow Standby LED will illuminate.
The GSU screen will display:
 Throttle channel “
Full Power
” position
6.
Advance the throttle stick to maximum. Press Select Menu or the LED I/O board button switch
again
to store the R/C system’s pulse width for the turbine full power position. The yellow
Standby
LED will turn off. If your ECU is set up for single channel operation skip to instruction number 11 .
The GSU screen will display:
 AUX channel minimum “
Off
” position.
7.
If the ECU is set for two channel operation, continue to program the auxiliary channel. The green
OK LED will illuminate again and initiates the learn mode for the three-position auxiliary channel.
8. Move the auxiliary channel to the minimum position for Off and press Select Menu or the LED I/O
board button switch again
to store the R/C system’s pulse width for immediate shutdown of the
turbine. The green OK LED will turn off and the red Pump running LED will illuminate.
The GSU screen will display:
 AUX channel center “
Start/Standby
” position
9.
Set the auxiliary channel to the middle position
for
Start/Standby and press Select Menu or the
LED I/O board button switch again
to store the R/C system’s pulse width for the turbine to start and
run. The red Pump running LED will turn off and
the yellow Standby LED will illuminate.
The GSU screen will display:
 AUX channel maximum “
Auto-Off
” position
10. Set the auxiliary channel to the maximum position for
Auto-Off and press Select Menu or the LED
I/O board button switch again
to store the R/C system’s pulse width for a normal auto shut-off of the
engine. The yellow Standby LED will turn off.