JetBlack VOLT V2, Быстрый старт

Страница: 15 / 24

VOLT™ V2 QUICK START GUIDE
15
CONNECTIVITY LIGHT (LED) DISPLAY
CONNECTIVITY LIGHT (LED) DISPLAY USING BLUETOOTH
CONNECTIVITY LIGHT (LED) DISPLAY USING ANT+
LED DISPLAY WHEN PERFORMING A FIRMWARE UPDATE
(Once connected to your power source)
1. Flashing RED / BLUE / GREEN will flash to show trainer is starting up.
(This process normally will complete in 2 -4 seconds after power is on)
2. BLINKING BLUE = Showing trainer is searching for a Bluetooth Device to connect.
3. SOLID BLUE = Bluetooth is connected and the trainer is active and sending signals to your device.
TIP: The JetBlack VOLT™ will only connect to one Bluetooth device at a time. Please ensure App is properly
closed before trying to connect to a different training App.
*DO NOT disconnect trainer or your device while the firmware is updating.
(Once connected to your power source)
1. Flashing RED / BLUE / GREEN will flash to show trainer is starting up.
(This process normally will complete in 2 -4 seconds after power is on)
2. BLINKING BLUE = Showing trainer is available.
3. ANT+ is at a “ON” status, App will show connection. Blue light will continue to blink.
1. Flashing RED / BLUE / GREEN will flash to show Trainer is starting up.
(This process normally will complete in 2 -4 seconds after power is on)
2. SOLID RED indicates the JBOOTLOADER (Firmware update service) is connected
3. SOLID BLUE indicates the trainer is connected and uploading
4. BLINKING BLUE = Showing trainer has completed upload and is searching for a Bluetooth Device to
connect. It is now safe to connect to your training app
Quick Release
Thru Axle