11
Mounting Rails
Hardware:
Front Rail, Rear Rail, (4) M8x16
Socket Head Cap Screws, (4) M8 Flat Washers,
(4) Lock Washers
Tool:
6
mm Hex Wrench
Refer to Figures 4 and 5.
1. Mount
the
front rail
(A) to the underside of the
table
(B) with two
socket head cap screws
(C),
two
lock washers
(D), and two
flat washers
(E).
2. Mount the
rear rail
(E) to the backside of the
table (F) with two
socket head cap screws
(G),
two
lock washers
(H) and two
flat washers
(J).
Mounting Left Extension Wing with
Miter Slot
Note:
If you have a sliding table, skip this section
and proceed to the
Mounting Sliding Table
section.
Hardware
:
Left Extension Wing, (4) M10x90
Socket Head Cap Screws, (4) M10 Lock Washer,
(4) Flat Washers
Tools:
Cross Point Screw Driver, Straight Edge,
Rubber Mallet, 8mm Hex Wrench
Referring to Figure 6:
1. Remove the arbor pulley guard (A). This is
only needed for the sliding table.
2. Attach left extension wing (B) to the table with
four socket head cap screws, four lock
washers and four flat washers (C). Snug but
do not tighten.
3. Slide extension wing toward the front edge of
the saw table until two faces are flush.
4. Place a straight edge across the table and left
extension wing. Align the extension wing the
same height as the saw table and tighten
socket head cap screws.
Note:
Use a rubber mallet to align wing with
table.
Miter Gauge for Left Extension Wing
Hardware:
Miter Gauge
Tools:
Cross Point Screw Driver, Square
1. Change the angle on the miter gauge by
loosening handle (E, Fig. 7) and turning the
fence (F, Fig. 7) to desired angle. To move
gauge beyond index stops of 45
°
and 90
°
, flip
back the stop (G, Fig. 7).
2. Adjust index stops by turning one of three
adjustment screws (H, Fig. 7). Use a square
to verify that the fence is 90° to the saw blade,
see Figure 7.
Figure 4
Figure 5
Figure 6
Figure 7
3. Slide fence to the left, or right by loosening
handle (I, Fig. 7). Make sure fence does not
interfere with the blade when cutting.
Содержание SuperSaw JWSS-10CS
