Jet ProShop II, Руководство по эксплуатации

Страница: 17 / 40

17
7.0 Electrical connections
The JPS-10TSL table saw is wired for 230-volt only.
The table saw comes with a plug designed for use
on a circuit with a
grounded outlet.
Before connecting to power source, be sure switch
is in
off position.
7.1 GROUNDING INSTRUCTIONS
1. All Grounded, Cord-connected Tools:
This machine must be grounded. In the event of a
malfunction or breakdown, grounding provides a
path of least resistance for electric current to
reduce the risk of electric shock. This tool is
equipped with an electric cord having an
equipment-grounding conductor and a grounding
plug. The plug must be plugged into a matching
outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
Do not modify the plug provided - if it will not fit the
outlet, have the proper outlet installed by a
qualified electrician.
Improper connection of the equipment-grounding
conductor can result in a risk of electric shock. The
conductor with insulation having an outer surface
that is green with or without yellow stripes is the
equipment-grounding conductor. If repair or
replacement of the electric cord or plug is
necessary, do not connect the equipment-
grounding conductor to a live terminal.
Check with a qualified
electrician or service personnel if the
grounding instructions are not completely
understood, or if in doubt as to whether the
tool is properly grounded. Failure to comply
may cause serious or fatal injury.
Use only 3-wire extension cords that have 3-prong
grounding plugs and 3-pole receptacles that accept
the tool's plug.
Repair or replace damaged or worn cord
immediately.
Make sure the tool is connected to an outlet having
the same configuration as the plug. No adapter is
available or should be used with this tool. If the tool
must be reconnected for use on a different type of
electric circuit, the reconnection should be made by
qualified service personnel; and after reconnection,
the tool should comply with all local codes and
ordinances.
7.2 Overload reset button (Only for
1Ph version, 725000-RU)
If saw becomes overloaded and the motor shuts off,
push re-set button above switch (Figure 6-2) to
restart. If overloading happens frequently, consult
the Troubleshooting section in this manual.
Figure 6-2
7.3 On/off switch lock-out
The Table Saw is equipped with a push-button
switch that will accept a safety padlock, as shown
in Figure 6-3. To safeguard your machine from
unauthorized operation and accidental starting by
young children, the use of a padlock (not included)
is highly recommended. Place the key in a location
that is inaccessible to children and others not
qualified to use the tool.
Figure 6-3
8.0 Adjustments
8.1 Blade raising/tilt mechanism
Never try to force the tilting
mechanism past the 45º or 90º stops. This may
cause blade misalignment.
See Figure 7-1.
To raise or lower blade, loosen lock knob (A) and
turn handwheel (B) on front of saw until desired
height is reached. Tighten lock knob. The blade
should be adjusted about 1/8" (3.175mm) above
the top surface of the material being cut.
To tilt blade, turn lock handle (C) counterclockwise
to loosen, turn handwheel (D) until desired angle is
obtained, then tighten lock handle (C) clockwise.