FX-383V
Connections and repairs to the electrical equipment may only
be carried out by qualified electricians.
If the machine cannot be operated after the wires have been
connected, please check the following items:
If the Emergency switch is released.
If the door of the electrical cabinet is properly closed and
switched ON (locked).
If the safety guard is in the proper position (closed).
5.4 Initial lubrication
The machine must be serviced at all lubrication points before
it is placed into service!
Failure to comply may cause serious damage.
5.5 Starting operation
Changing the spindle speed
The speed can be changed while machine is running. Then
the spindle speed can be adjusted to the proper cutting RPM
by using the spindle speed control knob (F). The spindle
speed ranges from 150 rpm to 2500 rpm.
Operation Cycle
Check if the 3 items mentioned in 5.3 were done properly.
Check that the head is secure.
Warning
!
Failure to secure the head can result in damage of the
machine and personal injury.
Secure the work piece to the table by using a vise or table
blocks.
Use the table hand wheels to position the work piece. Y-axis
for forward and backwards, X-axis for left and right.
Lock the table using two lock levers (L) for Y-axis, the lock
handle (M) for X-axis. Turn clockwise to lock and counter-
clockwise to unlock.
Suggested uses are as follows.
- Lock both tables when drilling.
- Lock the table of the non-milling axis when milling.
Adjust the table stops (N).
.
Use the spindle down feed levers to bring the tip of the drill to
the surface of the work piece and hold.
Set the depth stop (D, Fig 1) to the required depth.
Lift the drill or tapping bit off the work piece a bit.
Select the proper transmission mode and spindle speed (H).
Press start button switch (A) to begin spindle rotation (F).
Turn ON coolant pump lever switch (G), if necessary.
Warning!
For safety concern, please press the emergency switch to
shut down the machine completely after use. Pressing the
stop button alone does not release the remaining power in
the machine.
