Jet JWS-20CS, Инструкция по эксплуатации и каталог запасных частей, Страница: 13 / 28

13
Starting Pin
Only experienced, advanced
users should attempt starting pin shaping! If
you have never used this method, get training
from a qualified person who is knowledgeable
in starting pin shaping!
Failure to comply may cause serious injury!
Place the starting pin in one of the two threaded
holes in the table in front of the table rings.
1. Place work piece in the first position using the
starting pin as support (see Figure 20). Swing
the work into the cutter as shown in the
second position. The work is now supported
by the collar and starting pin.
2. After starting the cut, swing the work free of
the starting pin so it rides only against the
collar (see the third position, Figure 21).
Always feed against the action of the cutter.
Lubrication
To ensure easy movement when raising and
lowering spindle, occasionally apply a drop of light
oil on outside of spindle cartridge.
Spindle cartridge bearings are pre-lubricated and
sealed. They need no further care.
Figure 20
Figure 21