Jet JWP-208HH, Инструкция по эксплуатации и каталог запасных частей

Страница: 8 / 36

8
Handwheel
1. Remove the nut and washer from the gearbox
shaft, and place the handwheel onto the shaft
(Fig. 5), making sure it is oriented so the
handwheel slips over the key.
2. Place flat washer and hex nut on shaft and
tighten with wrench.
3. Mount the handle in the threaded hole in the
handwheel, and tighten with a wrench placed
over the flat on the handle.
Table Extension Rollers (JWP-208
only)
Mount the table extension rollers to the table using
the provided hex cap screws and washers
(A, Fig. 6). The rollers should be adjusted before
operating the planer; see
Adjusting Table
Extension Rollers on page 11.
Extension Tables (JWP-208HH only)
1. Mount a cast iron table to the edge of the
main table with three M8 x 25 hex cap screws
(Figure 6a). Do not fully tighten yet.
2. The extension table must be leveled with the
main table. Place a straight edge (such as a
jointed board) across both tables.
3. Insert three socket set screws with a hex
wrench, and screw them in or out as needed
until tables are level.
4. Securely tighten the hex cap screws.
5. Mount the second extension table to the
opposite side of the planer table, using the
same procedure.
Dust Collection Hood
The dust collection hood (Fig. 6b) comes standard
with the model JWP-208 planer, and helps
maintain a clean and safe work area. It is
assembled to the planer with the screws and
washers as shown.
IMPORTANT: Make sure all knives or knife
inserts are tight before operating machine. On
the helical head model, verify tightness of
each insert (re-torque) before using the
machine for the first time.
Figure 5
Figure 6 - JWP-208 only
Figure 6a - JWP-208HH only
Figure 6b