Jet JWL-1440VSK, Инструкция по эксплуатации и каталог запасных частей

Страница: 11 / 32

11
7.2 Voltage conversion
To switch the incoming power leads for 230 volt
operation:
1. Remove the junction box cover on the motor
and reconnect the leads according to the
diagram inside the cover. A similar diagram is
found at the back of this manual. (Note: In the
event of discrepancies, the diagram inside
junction box takes precedence.)
2. Remove the 120V plug on the end of the motor
cord and replace it with a UL/CSA listed plug
rated for 240V.
3. Alternatively, the lathe may be “hard-wired”
to the power source. If you are hard-wiring the
lathe to a panel, make sure a disconnect is
available for the operator. During hard-wiring of
the Lathe, make sure the fuses have been
removed or the breakers have been tripped in
the circuit to which the Lathe will be connected.
Place a warning placard on the fuse holder or
circuit breaker to prevent it being turned on
while the machine is being wired.
7.3 Extension cords
The use of extension cords is discouraged; try to
position equipment within reach of the power
source. If an extension cord becomes necessary, be
sure it is heavy enough to carry the current your
product will draw. An undersized cord will cause a
drop in line voltage resulting in loss of power and
overheating.
Table 1 shows recommended size to use depending
on cord length and nameplate ampere rating. If in
doubt, use the next heavier gauge. The smaller the
gauge number, the heavier the cord.
Ampere
Rating
Volts
Total length of
cord in feet
More
Than
Not
More
Than
120
240 25
50 50
100 100
200 150
300
AWG
0 0 0 6 18 16 16 14
0 6 10 18 16 14 12
10 12 16 16 14 12
12 16 14 12
Not
Recommended
Extension Cord Recommendations
Table 1
8.0 Adjustments
8.1 Headstock sliding
Push handle (A, Figure 9) toward motor to unlock.
Headstock will slide freely along the length of the
bed. Retighten handle before operating lathe.
8.2 Headstock rotation
1. Loosen handle (A, Figure 9).
2. Unscrew the knurled knob (B) counter-
clockwise until it can be pulled outward.
3. Pull knob outward and rotate headstock to
desired position. The headstock has seven
positive locking positions.
NOTE: Be careful not
to pinch your fingers against the bed as you
rotate the headstock.
4. Release knob (B) and it will seat itself with an
audible click when the headstock reaches a
positive lock position.
5. Tighten handle (A) by pulling it away from the
motor.
6. Rotate knob (B) clockwise until it engages the
threads.
Always tighten handle (A)
firmly before operating lathe.
Figure 9
8.3 Tailstock movement
To slide tailstock, push locking handle (C, Figure 10)
down toward the bed. Push locking handle upright
to lock tailstock in position.
To move the quill, loosen the lock handle (D) and
rotate the handwheel (E).
Make sure tailstock is locked to
bed (C, Figure 10) and quill is tightened (E)
before turning a spindle on the lathe.