10
Figure 5
To remove faceplate:
6. Make sure both set screws have been backed
out.
7. Engage spindle lock (A, Figure 5).
8. Place wrench (C) over flats, and turn to
unscrew faceplate.
7.5
Installing/removing spur center
Referring to Figure 6:
1. Make sure mating surfaces of spur center and
spindle are clean.
2. Drive spur center into workpiece. (See
section
11.3.1
)
3. Push spur center into spindle. NOTE: You do
not need to remove faceplate to install spur
center.
Figure 6
To remove spur center (Figure 7):
Hold spur center to prevent it from falling. (You
may wish to use a rag to protect your hand from
the sharp edges). Use knockout rod through
spindle hole to tap out spur center.
Figure 7
7.6
Installing/removing live center
Referring to Figure 8:
1. Rotate tailstock handwheel clockwise a few
times to advance quill.
2. Push live center into quill.
To remove live center:
3. Hold on to live center to prevent it from falling.
4. Rotate handwheel counterclockwise to retract
quill, until center releases from quill.
Figure 8
