Jet JWBS-20, Инструкция по эксплуатации и каталог запасных частей

Страница: 17 / 32

17
Operation
All electrical connections
must be made by a qualified electrician in
compliance with all relevant codes.
A plug needs to be purchased for the bandsaw
that matches the outlet you intend to use (A, Fig.
25).
Confirm that power at the site matches the
specifications of the before making any electrical
connections. Review the wiring diagrams on
pages 29-31 and the information on page 12.
The on/off switch (B, Fig. 26) is thermally
protected. If the saw motor is overloaded, or a
momentary interruption of electrical current is
sensed, the saw will shut off. Allow a few
minutes for the saw to cool down, then
reset by
pushing the off button .
Maintenance
Before doing maintenance on
the machine, disconnect it from the electrical
supply by pulling out the plug or switching
off the main switch. Failure to comply may
cause serious injury.
Keep bearing guides clean and free of build up.
Do not let saw dust build up in the upper and
lower wheel housings. Vacuum out frequently.
Keep the brake switch, located in the lower
wheel housing, clean and free of saw dust.
Connect the bandsaw to a JET dust collection
system.
Clean and grease the raising/lowering rack for
the upper bearing guides if it becomes difficult to
raise or lower.
Clean and oil the tensioning mechanism if it
becomes difficult to adjust.
Vacuum out the motor fan cover.
Figure 25
Figure 26