Jet JWBS-10OS, Инструкция по эксплуатации и каталог запасных частей

Страница: 10 / 24

10
Adjustments
Unplug the machine from the
power source before making any repairs or
adjustments. Failure to comply may cause
serious injury.
Tilting the Table
Referring to Figure 7:
1. Loosen the lock knob (A).
2. Tilt table (C) up to 50 degrees maximum to the
right or down 5 degrees to the left. The angle
can be read on the
scale (B) on the trunnion
bracket.
Note: Table perpendicular (90º) to the blade
corresponds to a scale indication of 0º.
3. Tighten the lock knob (A).
Note: The table stop (E) must be adjusted to permit
the table to tilt to the left.
90º Table Stop Adjustment
Adjusting the table stop
The table stop (E, Fig. 7) is typically set to stop the
table at 90º (perpendicular) with the blade.
1. Disconnect machine from power source.
2. Loosen lock knob (A, Fig. 7); then tilt the table
(C, Fig. 7) down, bringing it to rest against the
table stop (E, Fig. 7).
3. Use a square (J, Fig. 8) placed on the table
(C, Fig. 8) and against the blade (H, Fig. 8) to
see if the table is 90º to the blade.
4. If an adjustment is necessary, tilt the table up
to access the table stop (E, Fig. 7).
5. Loosen the jam nut (D, Fig. 7) and turn the
table stop (E, Fig. 7) in or out to raise or lower
the stop. Tighten the jam nut to hold the table
stop in place.
6. Tilt the table back to level, letting it rest against
the stop and confirm table is 90º with the blade
as described in step 3.
For left tilt down to 5º, the table stop (E, Fig. 7)
must be adjusted further.
Adjusting the table tilt indicator
1. Set the table at 90º with the blade.
2. Confirm that the table tilt indicator (F, Fig. 8)
points to zero.
If adjustment is required:
3. Slightly loosen screw securing indicator, adjust
indicator to point to zero; then re-tighten screw.
Figure 7
Figure 8
Figure 9