Jet JTAS-10XL, Инструкция по эксплуатации и каталог запасных частей

Страница: 10 / 36

10
Table Insert Adjustment
•
Hardware: Table Insert
•
Tools: Straight Edge, 2.5mm Hex Wrench
1. Lower blade completely.
2. Place the open end of the insert under the
splitter and lower the insert into the opening.
3. Adjust the table insert flush with the table by
turning four leveling screws (A, Fig. 9) and
using a straight edge.
Mounting Rails & Extension Table
With the extension wings properly aligned, the
rail and fence assembly can now be mounted to
the saw. See the Owner’s Manual for the
XACTA Fence Assembly Instructions. This will
address the mounting of the table, switch, rails
and fence.
Attaching the Switch Bracket Assembly
and Switch Brace to the Saw
•
Hardware: Switch Brace
•
Tool: 8mm Hex Wrench, 8mm Wrench
1. Place switch bracket assembly behind both
the front fence rail and the lip of the left
extension wing. (Do not place between the
front fence rail and the extension wing - this
will cause the front rail to distort and the
fence to bind).
2. Loosen (do not remove) hex socket cap
screw (A, Fig. 10).
3. Slide the open tab of the switch brace onto
the hex socket cap screw and washer.
Hand tighten only at this time.
4. Remove the nut and star washer from the
screw at the bottom of the switch plate.
5. Fasten the switch brace to the switch
bracket assembly with the star washer and
nut.
6. Align the switch and tighten all hardware.
Miter Gauge Operation
1. Operate miter gauge by loosening lock knob
(A, Fig. 11) and turning miter body (B, Fig.
11) to desired angle. To move gauge
beyond index stops of 45
°
and 90
°
, flip
down stop (C, Fig. 11).
2. Adjust index stops by turning one of three
adjustment screws (D, Fig. 11).
Note: Always make test cuts. Do not rely solely
on miter gauge indicator marks. There are
holes in the miter gauge body that will allow you
to mount a wooden extension fence.