3
Figure 4
Shoe Replacement
The shoe or sanding platen should be replaced when,
due to wear, it no longer sits flat but is convex in shape.
1. Disconnect sander from air source.
2.
Remove belt (see section titled “Belt
Replacement”).
3. Remove screw(s) and remove old shoe.
4. Install new shoe and fasten with screw(s). Make
sure insert on shoe end engages slot on sander
body.
Idle pulley replacement
Disconnect sander from air hose
before making any repair or adjustment. Failure to
comply may cause serious injury.
Use a screwdriver to remove the screw, then slide out
the shaft and remove the idle pulley. See Figure 5.
Figure 5
Bracket replacement
1. Disconnect sander from air source.
1. Remove
belt.
2. Pull out bracket in direction labeled A, Figure 6. Be
careful not to lose the spring.
Figure 6
3. Insert new bracket by lining up pin with pin groove.
See Figure 7.
Figure 7
Storage
1. Avoid storing sander in locations with high
humidity.
2. Before storing, apply four to five drops of air tool oil
at the air inlet and run for a brief time to circulate
the oil.
Speed adjustment
All models have a brass screw used for belt speed
adjustment found on the underside of the handle. This
has been set at the factory. It is highly recommended
that the end user
not
attempt any adjustment to the
speed control.
Replacement parts are listed on the following page. To order parts or reach our service department, call 1-800-274-
6848 Monday through Friday (see our website for business hours, www.jettools.com). Having the Model Number and
Serial Number of your machine available when you call will allow us to serve you quickly and accurately.