7
Figure 10
Bracket replacement
JSM-606/610/612
1. Disconnect sander from air source.
2. Remove
belt.
3. Pull out bracket in direction labeled A, Figure
11. Be careful not to lose spring.
Figure 11
4. Insert new bracket by lining up pin with pin
groove. See Figure 12.
Figure 12
Storage
1. Avoid storing sander in locations with high
humidity.
2. Before storing, apply four to five drops of air
tool oil at the air inlet and run for a short time.
Speed adjustment
All models have a brass screw used for belt speed
adjustment found on the underside of the handle.
This has been set at the factory. It is highly
recommended that the end user
not
attempt any
adjustment to the speed control.
Replacement Parts
Replacement parts are listed on the following
pages. To order parts or reach our service
department, call 1-800-274-6848 Monday through
Friday (see our website for business hours,
www.jettools.com). Having the Model Number and
Serial Number of your machine available when you
call will allow us to serve you quickly and
accurately.
