6
WARNING
Read and understand the entire contents of
this manual before attempting assembly or
operation!
Failure to comply may cause serious injury!
Contents of the Shipping Container
1. Buffer/Sander
4. Flange Washers 5/8" ID
4. Flange Washers 1” ID
2. Bushing
1/4”
2. Bushing
3/8”
2. Bushing
1/2”
2. Bushing
1”
2. Bushing
1-3/4”
2. Bushing
3”
2. Bushing
4”
2. Flat Washer ID 5/8” x OD 1-1/4”
1. Hex Nut 5/8” (right hand threads)
1. Hex Nut 5/8” (left hand threads)
1. Owner’s Manual & Warranty Card
Unpacking and Clean-Up
1. Remove product from shipping container.
Do not discard any shipping material until
the buffer/sander is set up and running
properly.
2. Clean all rust protected surfaces with a
cleaner degreaser.
Assembly
WARNING
Always unplug the sander / buffer before
performing any maintenance, or assembly.
Failure to comply may cause serious injury!
1. Mount buffer/sander to a solid workbench, or
stand.
2. Use the correct bushing (A, Fig. 1)
combination to go along with the buffing, or
sanding accessory (B, Fig. 1).
3.
Secure bushing and buffing/sander
assembly into place using the flat washer
(C, Fig. 1) and hex nut (D, Fig. 1). Note:
threads on the left end of shaft are for the
hex nut with left hand threads. Threads on
the right end of shaft are typical right hand
threads.
4. There is a flat spot (E, Fig. 1) on the shaft to
hold in place while tightening, or loosening
the hex nut.
