Jet JJP-12, Инструкция по эксплуатации и каталог запасных частей

Страница: 17 / 40

17
Planer Table Adjustment
Disconnect machine from
power source before making any adjustments.
Failure to comply may cause serious injury.
Checking Planer Table Parallel to Cutterhead
The planer table is set parallel to the cutterhead at
the factory and no further adjustment should be
needed. If your machine is planing a taper, first
check to see if the knives are properly adjusted in
the cutterhead (see
Setting Cutterhead Knives on
page 14) and make adjustments if necessary.
After the knives are confirmed to be properly set,
check to see if the work table is set parallel to the
cutterhead as follows.
1. Disconnect machine from power source.
2. Rotate the cutterhead such that one of the
knife blades (A, Fig. 14) is at the 6 o'clock
position.
Referring to Figure 15:
3. Place a gauge block (B) or another measuring
device on the work table (C) at one edge (D)
directly under the cutterhead.
4. Unlock the table lock handle (F).
5. With the handwheel (G), gently raise the
table (C) until the gauge block (B) makes slight
contact with the tip of the knife blade, then lock
the table.
6. Move the gauge block (B) to opposite end of
table (E).
If the distance from the table to tip of the knife
blade is the same at both ends, the table is
parallel to the cutterhead.
Adjusting Work Table Parallel to Cutterhead
If the work table is not parallel to the cutterhead,
perform the adjustment procedure as follows:
7. With a 13mm wrench, loosen four hex cap
screws (H) located at each corner of the
column support (J).
8. Bring the table parallel to the cutterhead by
adjusting four setscrews (K) located at each
corner of the column support (J) next to the
hex cap screws (H).
9. Repeat steps 3 – 6, and if further adjustment is
necessary, repeat steps 8, 9.
10. When the table is determined to be parallel to
the cutterhead, tighten the hex cap screws (H).
A
Figure 14
B C
D
E
J
H
K
F
G
Figure 15