Jet JBTS-10BT-3, Руководство оператора

Страница: 39 / 44

11
XACTA Fence
Screw the lock lever knob into the threaded handle
on the XACTA Fence II as shown in Figure 14.
The lock lever has three functional positions as
shown in Figure 15:
•
The upright position permits mounting and
removal of fence from the saw.
•
The unlock position permits easy fence
positioning.
•
The lower position locks the fence to the
front rail. The cam handle should be
pushed down firmly against the pin.
Leveling Fence to the Saw Table
1. Place the fence on the table and lock it.
2. View the fence from the left side of the saw
(Figure 16). Look for the space between the
table and the fence bottom to be equal along
the entire length of the fence (A, B, Fig. 16).
If adjustment is necessary:
3. Unlock the fence.
4. Using a 10mm wrench, loosen the lock nut that
secures the foot adjustment (C, Fig. 16)
5. Rotate the foot , retracting it such that it does
not come in contact with the back rail (Fig. 16).
6. Raise or lower two nylon adjustment screws
(D, Fig. 17) the same number of turns until the
space between the bottom of the fence and the
table is the same. Care must be taken to raise
or lower the fence on each side equally or the
fence may not be 90
°
to the table after the
height adjustment is performed.
When the space at points A and B (Fig. 16) are the
same:
7. Extend the foot (C, Fig. 16) by rotating it until it
just comes in contact with the back rail .
8. Tighten the lock nut to secure the foot ,
preventing it from further rotation.
Figure 14
Figure 15
Fence Side Plate
Table Top
A
C
B
Guide Tube
Back Rail
Front Rail
Figure 16
Figure 17