2
505420 JAT-420 Mini Die Grinder Combo Pack
Safety warnings
General air tool warnings
1.
Read and understand this entire manual
before attempting assembly or operation.
2.
Read and understand all warnings posted on
the tool and in this manual. Failure to comply
with all of these warnings may cause serious
injury.
3.
Replace warning labels if they become
obscured or removed.
4.
Do not use this tool for other than its intended
use. If used for other purposes, JET disclaims
any real or implied warranty and holds itself
harmless from any injury that may result from
that use.
5.
Always wear approved safety glasses or face
shield while using this tool. (Everyday
eyeglasses only have impact resistant lenses;
they are
not
safety glasses.)
6.
Wear ear protectors (plugs or muffs) if the
noise exceeds safe levels.
7.
Wear gloves and protective clothing if
operation produces sparks or flying particles.
Gloves should be tight-fitting, without frayed
fingers or hanging threads. Keep hands and
body away from the working area of tool.
8.
Do not operate an air tool continually at full
throttle without a work load on the tool.
9.
The air tool must be properly lubricated before
operating.
10. Do not operate air tool without its guards in
place. Do not modify the tool.
11. Do not operate this tool while tired or under
the influence of drugs, alcohol, or any
medication.
12. Adopt a comfortable posture with proper
balance, and maintain secure footing at all
times. Non-slip footwear or anti-skid floor
strips are recommended.
13. Do not wear loose clothing or jewelry. Confine
long hair.
14. Excessive air pressure and too much free
rotation may decrease life of the tool and may
cause a hazardous situation.
15. Check air hoses for wear, and keep them
away from heat and sharp edges. Repair or
replace damaged air hose immediately. Do
not carry tool by the air hose.
16. Air hose may cause tripping hazards; keep
hose away from traffic areas.
17. Do not use this tool near flammable objects,
or in potentially explosive environments. Do
not use near live electrical wires.
18. Do not use power tools in damp or wet
location, or expose them to rain. Keep work
area well lighted.
19. Do not leave a connected tool unattended.
When not in use, disconnect tool from air
source.
20. Shut off air supply and discharge any residual
pressure from tool before removing hose,
making adjustments, changing accessories,
or storing tool.
21. Make sure tool is switched off, and your finger
off the trigger, before connecting to air supply.
22. Remove adjusting keys and wrenches before
turning on tool.
23. Keep visitors a safe distance from the work
area.
Keep children away.
24. Give your work undivided attention. Looking
around, carrying on a conversation and
“horse-play” are careless acts that can result
in serious injury.
Содержание JAT-420
Страница 11: ...JET 11...
