Jet J-2210, Инструкция по эксплуатации и каталог запасных частей

Страница: 10 / 24

10
The Depth Indicator (Figure 5) can be set for
drilling depths up to 5”.
1. To set the Depth Indicator, lower the end of
the drill against the surface into which the
hole is to be drilled.
2. Loosen the handle on the pointer, and slide it
to the approximate position on the depth
gauge which matches your hole depth.
3. Tighten the handle, and then use the knurled
wheel to fine-adjust the pointer into position.
4. When drilling the hole, lower the spindle until
the pointer reaches zero.
A Speed Setting Handwheel is provided on the
left side of the head. The handwheel is turned
clockwise to increase spindle speed and
counterclockwise to reduce speed. Check the
speed by viewing the LED readout. Speed is
also dependent upon the belt and pulley
configuration (see “Belt Position”).
Only turn the speed setting
handwheel while the motor is running,
otherwise damage to the speed adjustment
mechanism may occur.
Adjustments
Work Table
The table can be raised or lowered to
accommodate the height of the workpiece. It
should be raised enough to allow for minimum
spindle movement. To raise or lower the table,
loosen the two locking handles and rotate the
crank handle. Always re-tighten both locking
handles before operating.
The work table can also be rotated on the
column by loosening the two locking handles
and shifting the table (along with the rack). This
is usually done when drilling large workpieces,
with the table shifted out of the way and the
work piece secured by using jigs in the T-slots
on the machine’s base.
Arbor/Chuck Removal
(An arbor and chuck are not included with the
drill press.)
1. Disconnect machine from power source.
2. Lower the spindle and rotate it by hand until
the slots in spindle and quill are aligned
(Figure 6).
3. Insert the drift key through the slot and tap it
in with a wood or rubber mallet until the
arbor/chuck drops out. Hold the arbor/chuck
to prevent it from falling.
Figure 5
Figure 6