Jet ELITE ECD-750BDV, Руководство пользователя

Страница: 10 / 59

10
CAUTION:
Catch chuck as it is released; allowing it to fall to floor may
damage it.
Wrench and key storage:
Wrenches, chuck key, and drift key can be stored on fixture on
right side of drill press head.
5.0 Electrical Connections
WARNING:
All electrical connections must be done by a qualified
electrician in compliance with all local codes and ordinances.
Failure to comply may result in serious injury.
The ECD-750BDV Drill Presses are rated at ~230V, PE, 50Hz
power supply, the drill press comes with a plug designed for use
on a circuit with a
grounded outlet.
Mains connection and any extension cords and plugs used must
comply with the information on the machine license plate.
The mains connection must have a 16A surge-proof fuse.
Only use extension cords marked H07RN-F, with wires 1,5mm
2
or more.
The total length of cord may not exceed 18 Meter
Power cords and plugs must be free from defects.
Connections and repairs to the electrical equipment may only
be carried out by qualified electricians.
The machine is equipped with 1.8m power cord and plug.
Before connecting to power source, be sure switch is in off
position.
5.1 Grounding instructions
This tool must be grounded. In the event of a malfunction or
breakdown, grounding provides a path of least resistance for
electric current to reduce the risk of electric shock. This tool is
equipped with an electric cord having an equipment-grounding
conductor and a grounding plug. The plug must be inserted into
an appropriate outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
WARNING:
Improper connection of the equipment-grounding conductor
can result in a risk of electric shock. Check with a qualified
electrician or service person if you are in doubt as to whether
the outlet is properly grounded. Do not modify the plug
provided with the tool.
The green/yellow conductor is the equipment-grounding
conductor. If repair or replacement of the electric cord or plug
is necessary, do not connect the equipment-grounding
conductor to a live terminal.
Use only 3-wire extension cords with grounding plugs.
Repair or replace damaged or worn cord immediately.
5.2 Extension cords
The use of extension cords is discouraged; try to position
machines near the power source. If an extension cord is
necessary, make sure it is in good condition.
An undersized cord will cause a drop in line voltage resulting in
loss of power and overheating.
Only use extension cords marked H07RN-F, with wires 1,5mm
2
or more.
The total length of cord may not exceed 18 Meter
Extension cords and plugs must be free from defects.
6.0 Adjustments
6.1 Depth stop adjustment
To drill multiple holes at the same preset depth, use the depth
stop:
1. Make a pencil mark on edge of workpiece to indicate
depth of hole.
2. With drill bit in chuck, lower down feed handle to advance
bit to your mark.
3. With your other hand, advance lock knob (H, Fig. 6-1) on
the depth stop rod until they are snug to the seat (J).
4. The drill bit will now advance to this point.
To release, move knob to top of depth stop.