4
2.
Attach foot lever (A, Fig. 2) to the lever
bracket (B, Fig. 2) with one hex cap bolt,
one flat washer, one lock washer (C, Fig. 2).
Tighten with a 14mm wrench.
WARNING
Keep hands and feet clear of table and
scissor lift openings while lowering load.
Failure to comply may cause serious injury!
3.
Pump the foot lever several cycles so that
the table is out of your way while attaching
the cable.
Note: Place a 2” x 4” board straight up and
down between the table and frame so that
the table can not come down on you while
attaching the cable.
4.
Route the cable (A, Fig. 3) into the cable nut
(B, Fig. 3).
Run the cable through the
lowering mechanism (C, Fig. 3) and pull the
cable tight. Tighten the hex nut (D, Fig. 3)
using a 14mm wrench.
Note: You may have to turn the hex socket
cap screw to line up the hole. This will allow
the cable to pass through freely.
Operation
1.
The table can be raised by pumping the foot
lever.
2.
To lower the table, slowly pull the release
lever.
3.
Before loading, lock the caster brake.
Maintenance
1.
Lubricate each friction point monthly with #2
tube grease.
2.
Check the movement and wear of wheels.
3.
Check for oil leakage from the hydraulic
cylinder.
4.
Store with table in lowered position.
Содержание DSLT-770
Страница 6: ...6 Parts Breakdown...
