GB - ENGLISH
Operating Instructions
Dear Customer,
Many thanks for the confidence you have shown in us with the purchase of your new JET-machine. This manual has been prepared
for the owner and operators of a
JET DSAN4-T Belt Gringder
to promote safety during installation, operation and maintenance
procedures. Please read and understand the information contained in these operating instructions and the accompanying
documents. To obtain maximum life and efficiency from your machine, and to use it safely, read this manual thoroughly and fol low
instructions carefully.
…Table of Contents
1. Declaration of conformity
2. Warranty
3. Safety
Authorized use
General safety notes
Remaining hazards
4. Machine specifications
Technical data
Noise emission
Contents of delivery
Description of machine
5. Transport and start up
Transpor and Installation of sander
Mains connection
Starting operation
Connection of dust collection
6. Setup and adjustments
Safety precautions
Adjusting belt tracking
Angle Adjust
7. Machine operation
Belt sanding
Replacing belt
8. Maintenance and adjustment
keep machine and workshop clean
Lubrication
Motor and electics
9. Troubleshooting
10. Environmental protection
1. Declaration of conformity
On our own responsibility we hereby declare that this
product complies with regulations
2. Warranty
JPW (Tool) AG guarantees that the supplied product(s)
is/are free from material defects and manufacturing
faults.
This warranty does not cover any defects which are
caused, either directly or indirectly, by incorrect use,
carelessness, damage due to accidents, repairs or
inadequate maintenance or cleaning as well as normal
wear and tear.
Further details on warranty (e.g. warranty period) can
be found in the General Terms and Conditions (GTC)
that are an integral part of the contract.
These GTC may be viewed on the website of your
dealer or sent to you upon request.
JPW (Tool) AG reserves the right to make changes to
the product and accessories at any time.
3. Safety
3.1 Authorized use
This belt Grinder is designed for sanding Metal and
similar materials only. Sanding of other materials is not
permitted and may be carried out in specific cases only
after consulting with the manufacturer.
The machine is not suitable for wet sanding. The
machine is not designed to be used in explosive
environment.
The workpiece must allow to safely be loaded,
supported and guided.
The proper use also includes compliance with the
operating and maintenance instructions given in this
manual.
The machine must be operated only by persons familiar
with its operation and maintenance and who are familiar
with its hazards.
The required minimum age must be observed.
The machine must only be used in a technically perfect
condition.
Do not attempt to operate tool until it is completely
assembled according to the instructions
When working on the machine, all safety mechanisms
and covers must be mounted.
In addition to the safety requirements contained in
these operating instructions and your country’s
applicable regulations, you should observe the
generally recognized technical rules concerning the
operation of woodworking machines.
Any other use exceeds authorization.
In the event of unauthorized use of the machine, the
manufacturer renounces all liability and the
responsibility is transferred exclusively to the operator
