Jet DC-1200FS, Руководство пользователя

Страница: 7 / 15

7
Assembly
WARNING
The dust collector must be disconnected
from the power source during assembly
(unplug). Failure to comply may result in
serious injury!
1. Position the base on its side. Mount the two
front, fixed casters on the base with four M6
M6x12 hex cap screws, four lock washers
and four M6 flat washers, Figure 1.
2. Thread two hex nuts onto the caster shaft.
Mount the rear, pivot casters and supporting
bars to the base with two M10 flat washers,
two M10 lock washers and two acorn nuts,
Figure 2. While holding the hex nut that
was threaded onto the caster shaft with a
wrench, tighten the acorn nut.
3. Place the base upright on its casters.
Attach the lower stand, air guard (A, Fig.3)
facing out, to the base with eight M8x20 cap
screws (B, Fig. 3) and eight M8 lock
washers.