9
Electrical Connections
WARNING
All electrical connections must be done by a
qualified electrician. All adjustments or
repairs must be done with the dust collector
disconnected from the power source,
unplugged. Failure to comply may result in
serious injury!
The DC-1200C dust collector is rated at 230V
Only and is not supplied with a plug.
Use a
plug and outlet rated at least 20 amps.
The
circuit for the machine should also be protected
by at least a 20 amp circuit breaker or fuse.
Keep in mind that a curcuit being used by other
machines, tools, lights, heaters, etc. at the same
time will add to the electrical load. A dedicated
curcuit to the dust collector will give you the
best results since dust collectors are generally
used at the same time other tools are running.
Before hooking up to the power source, make
sure that the switch is in the off position.
Turning the Machine On & Off
Before hooking up to the power source, make
sure that the switch is in the off position.
The dust collector can be turned on by pressing
the start button mounted next to the motor.
Press the stop button to turn off the dust
collector.
Maintenance
WARNING
Never perform maintenace on this machine
before turning switch off and removing plug
from power source, unplug.
Failure to comply may cause serious injury!
Cleaning the Filter
Clean both the filter and collector bag frequently
to keep the collector's performance at its
optimum.
To clean the filter turn the handle a couple
rotations so the dust falls into the collector bag.
Removing the Collector Bag
CAUTION
Wearing a particle mask/respirator for
protection against fine dust particles during
cleaning is highly recommended.
1.
Disconnect the machine from the power
source, unplug.
2.
Remove the collector bag by pushing the
ring of the collector bag upwards at an angle
and pulling the bag and snap ring out.
3.
Empty the contents into an appropriate
container.
4.
See Page 8 for details on replacing the
collector bags.
Motor
Make frequent inspections of the motor fan and
blow out (with low pressure air hose) or vacuum
any accumulation of foreign material in order to
maintain normal motor ventilation.
Connecting
the
Dust
collector
to
a
Machine
Use the proper type hose to connect the dust
collector to the machine being operated. Dryer
vent hose is not acceptable for this purpose.
Contact your nearest JET distributor for the full
line
of
JET
Dust
Collector
Hoses
and
Accessories.
Customize your installation and
obtain maximum performance with JET's dust
hoods, hoses, clamps, fittings, and blast gates.
You can also purchase the JET “Dust Collection
Basics Video” stock # JW1050V through your
JET Distributor
Grounding the Dust Collection System
The dust collection system includes the dust
collector and the hose, or duct work you use to
connect the tools. The dust collector is grounded
though the ground wire in the cord. The hose or
duct work you use to connect the tool to the dust
collector must also be grounded.
To assist in
grounding your system you can purchase the JET
“Dust Collector Grounding Kit” stock # JW1053,
and also the JET “Dust Collection Basics Video”
stock # JW1050V through JET Distributors.
