9
Maintenance
WARNING
Never perform maintenace on this machine
before turning switch off and removing plug
from power source, unplug.
Failure to comply may cause serious injury!
Cleaning the Filter Bag
CAUTION
Wearing a particle mask/respirator for
protection against fine dust particles during
cleaning is highly recommended.
During first use and after cleaning, the filter bag
may allow some dust to escape. This is normal
and will stop after a short period of time.
Clean
both
the
filter
and
collector
bags
frequently to keep the collector's performance at
its optimum. To clean:
1.
Disconnect the machine from the power
source.
2.
Unhook the filter bag from the hanger and
shake the bag so that the majority of the
dust falls into the collector bag.
3.
Loosen the retaining strap, and remove the
filter bag from the housing.
4.
Turn the bag inside out and clean.
5.
Turn the bag outside in and re-attach to the
housing using the retainer strap to secure.
Removing the Collector Bag
1.
Disconnect the machine from the power
source, unplug.
2.
Remove the collector bag by pushing the
ring of the collector bag upwards and pulling
the bag out at an angle.
3.
Empty the contents into an appropriate
container.
4.
Turn the bag inside out and clean.
5.
Turn the bag outside in and insert into the
housing.
Use the proper type hose to connect the dust
collector to the machine being operated. Dryer
vent hose is not acceptable for this purpose.
Contact your nearest JET distributor for the full
line
of
JET
Dust
Collector
Hoses
and
Accessories.
Customize your installation and
obtain maximum performance with JET's dust
hoods, hoses, clamps, fittings, and blast gates.
Accessories.
Motor
Make frequent inspections of the motor fan and
blow out (with low pressure air hose) or vacuum
any accumulation of foreign material in order to
maintain normal motor ventilation.
Connecting
the
Dust
collector
to
a
Machine
Use the proper type hose to connect the dust
collector to the machine being operated. Dryer
vent hose is not acceptable for this purpose.
Contact your nearest JET distributor for the full
line
of
JET
Dust
Collector
Hoses
and
Accessories.
Customize your installation and
obtain maximum performance with JET's dust
hoods, hoses, clamps, fittings, and blast gates.
You can also purchase the JET “Dust Collection
Basics Video” stock # JW1050V through your
JET Distributor
Grounding the Dust Collection System
The dust collection system includes the dust
collector and the hose, or duct work you use to
connect the tools. The dust collector is grounded
though the ground wire in the cord. The hose or
duct work you use to connect the tool to the dust
collector must also be grounded.
To assist in
grounding your system you can purchase the JET
“Dust Collector Grounding Kit” stock # JW1053,
and also the JET “Dust Collection Basics Video”
stock # JW1050V through JET Distributors.
