Jet BD-920W, Инструкция по эксплуатации и каталог запасных частей

Страница: 18 / 48

18
Four ‐ way Tool Post
The four-way tool post is mounted on the top slide
and allows for tools to be clamped. Loosen the
center clamp handle to rotate any of the four tools
into position (Figure 29).
Use a minimum of two clamping screws when
installing a cutting tool.
Change Gears
There are nine gears (Figure 30) with different
numbers of teeth (32, 36, 38, 40, 44, 46, 48, 52 and
56). They can be combined for different speeds and
feeds as required. See chart on headstock.
Adjustment and Replacement
Adjustment of Main Spindle Bearings
The main spindle bearings are adjusted at the
factory. If end play becomes evident after
considerable use, the bearings may be adjusted.
Loosen setscrew (1, Figure 31) in the slotted nut (2,
Figure 31) on the back of the spindle. Tighten
slotted nut until all end play is taken up. The spindle
should still revolve freely.
Caution: excessive
tightening or preloading will damage the bearing .
Re-tighten set screw (1, Figure 32).
Adjustment of Cross and Top Slide
Each slide is fitted with a gib strip and can be
adjusted with screw (1, Figure 32) fitted with lock
nuts (2, Figure 32). Loosen the lock nuts to adjust
the screws, and re-tighten lock nuts to secure the
setting.
Figure 32
Figure 29
Figure 30
Figure 31