Jet BD-10VS, Руководство по эксплуатации

Страница: 42 / 67

Interval Where? What? How?
as required
S
l
i
d
e
w
a
y
s
Readjust
→
Loosen the counternuts
→
Turn the set screw slighty clockise and secure
the set screws again using the counternut
INFORMATION
A 90 turn of the set screw corresponds to a
travel of approximately 0.2mm.Make any
readjustent of the set screw in short steps.
The tapered gib for guiding the lead screw nut
has been factory-set and does not normally need
to be readjusted.
INFORMATION
The spindle bearings are permanently greased.Greasing during the
maintenance intervals is not necessary.Further greasing of the
spindle bearings is only necessary in case of de-and remounting of the spindle bearing
Page 40