Jet 725005, Инструкция по сборке и каталог запасных частей

Страница: 11 / 20

11
6.4.2 Square to Table
8. Place a square on table and against side of
fence, as shown in Figure 13. Lock fence
down with handle. The fence should be 90°
to table.
9. If fence is not 90° to table, unlock the fence
and rotate one of two nylon adjustment
screws (clockwise will raise that side of the
fence assembly, counterclockwise will
lower). See Figure 13. Lock fence and
check adjustment again. Continue to adjust
as needed.
6.4.3 Parallel to Miter Slot
10. Check parallelism of fence by aligning side
of fence with edge of miter slot in table.
Lock fence down with handle.
11. If fence side is not parallel with miter slot,
unlock fence and lift it off guide rail. Adjust
one of two set screws (Figure 14) until fence
is parallel to miter slot along its entire length
when in locked position.
NOTE: You may need to re-adjust clamping
pressure after aligning fence.
6.4.4 Clamping Pressure
The fence has been adjusted by the
manufacturer to lock securely when the handle
is pushed down. If adjustment is needed, unlock
fence and lift it off guide rail. Adjust
equally two
set screws (Figure 14) until fence is held
securely when lock handle is pushed down.
6.5 Attaching scale
Disconnect saw from power
source (unplug).
Important: The fence must be square to the
table and parallel to the miter slot before
attaching the scale to the guide tube. Follow all
preceding instructions before continuing.
1. Install a blade on the saw, and raise the
blade above the table surface. Lift the blade
guard and the anti-kickback pawl out of the
way.
2. Slide the fence until it just contacts the
cutting tips of the blade (Figure 15) and lock
it down with the handle. Do not force the
fence into the blade.
3. Center the cursor on the screws to allow
future adjustment on both sides of the
cursor line. See Figure 16. Draw a line on
the guide tube even with the cursor line.
Figure 13
Figure 14
Figure 15