Jet 708358, Инструкция по эксплуатации и каталог запасных частей

Страница: 4 / 32

4
SPEED RECOMMENDATIONS
Diameter of Work Roughing RPM General Cutting RPM Finishing RPM
Under 2" 1500 3000 3000
2 to 4" 600 1500 2300
4 to 6" 450 1100 1500
6 to 8" 450 600 1100
8 to 10" 450 600 850
10 to 12" 450 600 850
12 to 14" 450 450 600
26. When sanding, remove the tool rest from the machine, apply light pressure and use a slow speed
to avoid heat build up.
27. When turning large diameter pieces, such as bowls, always operate the lathe at low speeds. See
the speed recommendation chart.
28. Do not attempt to engage the spindle lock pin until the spindle has stopped. If leaving the
machine area, turn it off and wait until the spindle stops before departing.
29. Make no adjustments except speed changes with the spindle rotating and always disconnect the
machine from the power source when performing maintenance to avoid accidental starting or
electrical shock.
30. Provide for adequate space surrounding work area and non-glare, overhead lighting.
31. When stopping the lathe, never grab the part or faceplate to slow it down. Let the work coast to a
stop.
32. Use only JET factory authorized replacement parts and accessories; otherwise, the warranty and
guarantee are null and void.
33. Do not use this JET wood lathe for other than its intended purpose. If used for other purposes,
JET disclaims any real or implied warranty and holds itself harmless from any injury that may
result from that use.
Warnings