Using a combination or mach
ine
square
,
position it up against the
front face
of the Fence
Extrusion. To square the fence
to the table
, make sure the square is flush with the table and flush
against
the extrusion
and the gauge is sitting flat on your table. Rotate the fence until you see
no
light
between
the square
and the fence
, re-tighten screws 9.1 & 9.2 on the left
and right
side of
the gauge. (See
Figure 1
4
)
c
.
Slide your Fence Extrusion (Part #33) back onto the Mite-R-Excel II
™
(See
Figure 1
4
) and
tighten it in position using the Fence Knobs (Part # 45)
a
.
Loosen off screws 9.1 & 9.2 on both sides of the fence using the 5/32” Hex Key (Part # 59)
provided.
b.
Figure 1
4
Vertically Squaring the
M
ite
-R-E
xcel
II™
1
2
Remove the Fence Extrusion (Part #33) from the Mite-R-Excel II
™
and
remove the
Mite-R-Excel
II
™
from the
table saw.
b
.
Loosen the Fence Knobs (Part #45) and disengage the Fence Locating Pin Knob (Part #40).
a
.
Squaring the Mite-R-Excel
II™
C
45
9.1
33
9.2
