Look at both the left and right side of
the gauge
.
If there is any
gap or light between the
combination square
blade
and the Fence Mount
on either the left or right side,
(Part #44)
follow steps
i) thru iii)
below.
d
.
NOTE: Once the set screw engages with the gauge body, only turn the screw
in small
increments
while checking to see if the gap has closed after each turn. You will not need
to turn the set screw too many times before the gap is gone.
R
e-attach the Fence
Extrusion
.
Figure 1
5
Using
a
machine/combination square,
a
l
ign
the base against the guide bar (Part #56) and
the
ruler/straight edge against the Fence Mount (Part # 44)
See
Figure 1
5
.
c
.
NOTE: Steps (
b
) thru (
e
) do not have to be done on the saw.
Loosen the 10-32 x 7/8" Socket Head Cap Screws (Part 9.3 and 9.4)
on the side with gap.
i
)
ii
)
With 1/8” hex key provided, tighten the 1/4-28 x 5/16” Flat Point Set Screw (Part # 39) until
the set screw presses against the gauge body between the blade and fence mount (Part #44)
See
NOTE
below.
iii
)
Once the gauge is flush and no light is seen on both sides of the fence mount, r
etighten the
10-32 x 7/8" Socket Head Cap Screws (Part 9.3 and 9.4)
1
3
e
.
39
44
9.4
9.
3
56
C
Left Gap
Right Gap
Engage the Fence Locating Pin Knob (Part #40) and tighten the fence knobs (Part #45).
f
.
