1
WARNING
: Some dust created by power sanding, sawing, grinding,
drilling, and other construction activities contains chemicals known
to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
●
lead from lead-based paint
●
crystalline silica from bricks and cement and other masonry
products, and
●
arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you
do this type of work. To reduce your exposure to these chemicals:
work in a well ventilated area, and work with approved safety
equipment, such as those dust masks that are specifically designed
to filter out microscopic particles.
2
Read, understand, and follow the instructions packaged with the
router table and router lift. Do not plug in Remote Power until
Router Table Motor is fully installed.
3
Only use the following recommended router tables and router lifts
with this motor.
JessEm Mast-R-Lift II #02120
JessEm Mast-R-Lift II #02121
JessEm Mast-R-Lift Excel II #02202
Using tables and lifts that are not specifically recommended may
not
properly secure the Router Table Motor. An
improperly secured
Motor increases the risk of injury or product
damage.
4
Do not place motor in a router base or hold motor by hand during
use. Motor is designed only for use properly secured in a
recommended JessEm router lift or router table. This motor is not
designed for use in a
JESSEM
router base.
5
Always wear safety goggles and dust mask. Use only in a well
ventilated area. Using personal safety devices and in a safe
environment reduce the risk for injury.
6
Some woods contain preservatives that can be toxic. Take
extra care to prevent inhalation and skin contact when
working with these materials. Request, and follow, any
safety information available from your material supplier.
7
Always make sure the workpiece is free from nails, screws
and other foreign objects. Keep the working edge away
from the clamping surface. Cutting these objects can
cause loss of control of the workpiece and damage to the
bit.
8
Never place hands near cutting surface.
9
Never use dull or damaged bits. Sharp bits must be
handled with care. Damaged bits can break during use.
Dull bits require more force, which could cause the bit to
break. Damaged bits can throw carbide pieces and burn
the workpiece.
10
After changing the bit or making any adjustments, make
sure the collet nut and any other adjustment devices are
securely tightened. Loose adjustment devices can
unexpectedly shift, causing loss of control. Loose rotating
components will be violently thrown. Watch for vibration or
wobbling that could indicate an improperly installed bit.
11
Always keep the power supply cord away from moving
parts on the tool.
12
Never start the tool when the bit is in contact with the
material. The bit cutting edge may grab the material
causing loss of control of the workpiece.
13
Never touch the bit during or immediately after use. After
use the bit may be hot enough to burn bare skin.
14
To reduce the risk of injury, avoid “climb cutting.” Climb
cutting can cause the workpiece to be thrown violently out
of your control. Even small router bits can result in climb
cutting. Always feed the workpiece against the cutter
rotation.
SPECIFIC SAFETY RULES
GROUNDING
JessEm Mast-R-Lift Excel #0220
2
GROUNDING
Double insulated tools are constructed throughout with two seperate
"layers" of electrical insulation between you and the tool's electrical
system.
Tools built with this insulation system are not intended to be
grounded. As a result, your tool is equipped with a two-prong plug
which permits you to use extension cords without concern for
maintaining a ground connection.
NOTE:
Double insulation does not take the place of normal safety
precautions when operating this tool the insulation system is for
added protection against injury resulting from a possible electrical
insulation failure within the tool.
