JESS WELDING G450 S, Руководство по эксплуатации

Страница: 38 / 48

EN - 14
BA-0003 • 2020-04-09
7 Operation G450 S | G600 S
7.1.2 G600 S control elements
Fig. 7 G600 S control elements
A Internal/external rotary switch
B Digital voltmeter/ammeter
C Remote control socket
D Welding cable connection bush (+)
E Welding cable connection bush (−)
F Fine-wire fuse
G Mains indicator light
H Main switch
I Temperature fault light
J Welding current knob
B
C
A
D
E
F
G
H
I
J
Tab. 5 G600 S control elements
Pos. Description
A Internal/external rotary switch. For switching between the internal and external operating modes
(remote control).
B Digital voltmeter/ammeter. Indicates the present current and voltage. At the end of the welding process, the
final values remain on the display for about 15 seconds.
C 10-pole remote control socket. For connecting a foot or hand-operated remote control. See the circuit diagram
for connection.
D Welding cable connection bush (+)
E Welding cable connection bush (−)
F Fine-wire fuse F1. 2 A time-lag for control transformer.
G Mains indicator light. Illuminates when the machine is switched on.
H Main switch Position “0”: machine off. Position “I”: machine on. The mains indicator light illuminates. The fan is
running.
I Temperature fault light. Illuminates if the welding transformer or thyristor set overheats. The arc can no longer
be started. If the fan is running, the machine will ready for operation again after approximately 5 minutes.
J Welding current knob. Continuous adjustment of the welding current between 35 A and 600 A.