Jersey Jack Pinball Dialed in!, Руководство по эксплуатации

Страница: 91 / 372

The Dialed In Menu System B-49
USB Update
Use the USB Update utility to apply a Dialed In delta software update to your game. Note: The
update must be downloaded from the JJP® support website ( https://www.jerseyjackpinball.com/
support/ ), using a separate computer. Copy the “di_update” folder from your computer onto an
empty USB memory stick (i.e. it should be the only folder on the stick). Power up the game, open
the coin door, and use the diagnostics buttons to enter the USB Update utility; the LCD monitor will
display the screen shown in figure B39.
Locate the end of the USB extension cable, just inside the open coin door (to the left of the coin
box). Remove the Bluetooth dongle from the connector at the end of the cable and set it aside.
Fully insert the USB stick in its place (if your USB stick is equipped with an “in-use” light, it will
illuminate).
To attempt the USB delta update, press the Enter button. The game’s playfield and LCD monitor will
go blank/dark for approximately 15-30 seconds (depending upon the size of the update). You can
abort the update process by pressing the Back/Escape button. When the game and monitor come
back to life, verify that the delta update installed successfully by re-entering the Dialed In Menu
System. The installed software version is displayed in the lower, right hand corner of most menu
system screens.
When you’re satisfied that the delta update was applied correctly, remove the USB stick from the
end of the USB extension cable (there is no need to power down the game before performing this
action). To exit the USB Update utility, press the Back/Escape button.
If you removed the game's Bluetooth dongle, plug it back into the end of the USB extension cable.
Figure B39. USB Update utility screen.