Jerr-Dan LIGHT DUTY, Инструкция по эксплуатации, техническому обслуживанию и запасным частям

Страница: 25 / 100

•
NOTE: TO ENGAGE CLUTCH simply pull out on the "T" handlE
and rotate 90° clockwise and release. If the clutch doe!
not engage. operate the valve winch control until thE
clutch engages. The winch is now ready for pulling. DC
NOT allemptto pull a load unless the handle is fully a
the 'IN' position.
2. Lower the winch control handle to wind the cable and pull thE
load onto the deck.
CAUTION: Maintain a minimum of 5 turns of cable on the spool at a
times. Also maintain a uniform wrap of the cable on thl
spool.
~
1
r"l_ - .
j (o. ..et:.~
D. TIlting the DecklUnloading
1. Position
Park the truck with the rear of the deck approximately 12 feet fror
desired position of vehicle being unloaded.
ta. Set the parking brake.
I b. With the engine running. engage the PTO per instructions in th
truck cab.
Ie. Set the auxiliary throllie. After operating the unit several time
one will establish a feel for the optimum speed. DO NO
OVERSPEED.
1d. Partially release bindings of the load but maintain restrair
against movement of the load in any direction.
•
•
CAUTION:
CAUTION:
CAUTION:
CAUTION:
Clutch must be totally engaged before starting winch.
Do not disengage clutch under load.
Also remember that cables can break, winches fall am
hooks become disengaged. DO NOT WORK BELeY
THE LOAD!
Replace cable when worn or damaged. Always wea
gloves when handling cable. DO NOT USE CABU
CLAMPS.
Rev. _
2.4
Date _
Ea
st
ern
W
re
cke
r Sa
le
s
In
c