SUBJECT TO TECHNICAL CHANGES.
JERGENS INC. · PHONE: 216.486.5540 · FAX: 216.481.6193 /553720 / 553721/
6
INSTALLATION MANUAL
ZPS-
K5.3,
K10.3, K20.3 CLAMPING
MODULE WITH SENSOR
MONITORING, MOUNTING FLANGE
877.426.2504
0.4
General safety instructions
The following regulations and recommendations correspond to
the applicable legal regulations and are largely based on the
observance of such safety regulations.
JERGENS INC. is not liable for any harm to persons or
property, which can be traced back to a disregard for the
applicable
safety
regulations and/or the instructions
contained in this manual. The latest version of the
installation manual shall apply
.
All operators concerned are therefore urged to follow and apply
the instructions below, and to strictly comply with the applicable
accident protection regulations of the country, where the system
is installed and used.
All ordinary and extraordinary maintenance steps must be
undertaken with the pressure supply cut off.
Before connecting the pressure, check whether the operating
pressure is in accordance with the maximum allowable operating
pressure.
Transportation,
installation,
operation
and
ordinary
or
extraordinary maintenance of the Zero Point System may be
undertaken only by personnel meeting the requirements stated in
sections 0.1 and 0.2.
0.5
Behavior in emergencies
In emergencies, it is recommended that the procedures from the
operating and maintenance instructions of the machine on which
the Zero Point System (ZPS) is installed should be followed in
emergencies.
In particular, measures must be taken so that no danger to
persons or property can arise in case of a defect.
In case of fire, take the designated extinguishing measures and
make sure no operating pressure is present.
