Jenx LADYBIRD, Инструкция по эксплуатации, Страница: 14 / 26

14
Te
chnical User
GB
FOR FREE ADVICE ON THE USE OF THIS PRODUCT, PLEASE CONTACT OUR SALES SUPPORT TEAM
Jenx Limited, Wardsend Road, Sheffield, S6 1RQ. Tel: +44 (0)114 285 3376. Fax: +44 (0)114 285 3528. info@jenx.com www.jenx.com
Making & Using the Adjustments
Do not use this product if you suspect it is faulty or broken.
Contact Jenx Limited immediately for advice. +44 (0) 114 285 3376
Never Leave your child unattended while using this product
POSITIONING SUGGESTIONS GIVEN IN THIS SECTION SHOULD BE TREATED AS A GUIDE ONLY. YOU SHOULD
ALWAYS CONSULT YOUR THERAPIST OR MEDICAL PRACTITIONER BEFORE USING THIS PRODUCT.
Always secure the child by using all of the positioning straps and safety straps provided. Velcro
should overlap by at least 3 inches
(7.5 cm) on all straps before you begin to make any other
adjustments. Ensure the safety strap and positioning strap are adjusted for each child and for
changes of clothing.
WHY?
To allow the child to be taken out of the seat without removing the tray and to offer complete upper trunk
control when needed. The extension wings should be used to ensure that your child’s spine is kept in a
straight line.
Tray Extension Wings and Side Panels .
HOW?
Under the tray there are two black wing nuts Fig 11. By loosening these, it is possible to move the
extension wings to fit snugly to your child to support their trunk. These same wing nuts are loosened to
move the extension wings right out of the way to create lots of space for when you place your child into the
Ladybird/Turtle or when you take them out. Loosen the wing nuts, push the extension wings away from the
tray and then out to the side. This adjustment means that the tray does not need to be removed to put
your child into the chair. Take care that the L-shaped slots are not left exposed to trap the child’s fingers.
Tighten wingnuts after any adjustment.
To adjust the height of the side pads, using the Allen key supplied loosen the screws which attach the side
pads Fig 12 and move along the slot to the required position.
The tray extension wings are also interchangeable, enabling the side pads to have more height adjustment.
To do this using the Allen key supplied remove the two flat head screws in the tray extension wings, turn
the extension wing upside down, swapping right for left replacing the screws on the other side of the
extension wing. Remove the flat head screws which attach the side pads and turn them over. Replace the
screws. Tighten all screws after any adjustment.
Fig 11
Fig 12
Clear all items from the tray before adjustment.
Do not use hot or cold drinks on the tray while in the angled position.