40
VX3010
BUILT-IN SWC INTERFACE
The built-in SWC Interface is compatible with most vehicles equipped with “resis-
tive type” OE steering wheels.
Note:
Not all OE steering wheel functions may be supported by the VX3010.
The following controls are available for most vehicles:
1. Volume
Up (+)
4. Seek Up
(Next)
7. Preset (+) 10. Answer
2. Volume
Down (-)
5. Seek
Down (Prev)
8. Preset (-) 11.BT Send
3. Mute
6. Source
9. Band
12.BT End
To access the SWC Controls for programing, touch the Steering Wheel icon on the
second page of the Main Source Menu.
SWC Programing
Up to 12 steering wheel control functions can be programmed via the built-in SWC
interface. Not all functions may be supported for each vehicle.
1. Popular OE steering wheel functions are already pre-programmed from the fac-
tory. If your vehicle does not support the exact same functions already pre-pro-
grammed, you will need to clear / reset the SWC interface and program in the
exact functions of your vehicle. To clear / reset the SWC interface, press and hold
“Reset” for 2 seconds.
2. To begin programming the SWC interface after it has been cleared / reset, press a
number 1 ~ 12, then press a function. A check mark should appear corresponding
to the number and function. Continue programming in this manner until all of
the OE steering wheel control functions are completed.
NOTE:
Functions 1 ~ 12 must be assigned to a function on the OE steering wheel. For example, if
the OE steering wheel does not support and Preset -, then these functions must be cleared
/ reset in order for the other functions to work correctly.
3. To “learn” the programming completed in step 2 above, press the “Program” but-
ton. You will then be prompted to push each button on the OE steering wheel (for
1 second), so the unit can learn the corresponding function.
4. SWC learning / programming is now complete.
Figure 31. SWC Programing Screens
128-9270 VX3010 Operating Instructions 02 20 2014.indd 40
2/20/2014 5:55:44 PM
