15
VM9116
To exit the balance-fader:
• touch the
X.
button on the top left corner of the screen or press and hold the
rotary encoder.
• touch the
EQ
button on the left side of the screen to display the equalizer
screen.
System.Reset
To correct a system halt or other illegal operation,
use the tip of a pen to press the reset button
[RESET] Button
located on the front bottom-right corner of the unit.
After a system reset, the unit restores all factory default settings.
NOTE: If the unit is reset while a DVD is playing, the DVD resumes play once the
reset is complete.
Image/Display.Settings
Video Output Modes
Table 4 shows the video output mode for each playing source.
Table.4:.Video.Output.Modes
Playing.Source
Video.Output.Modes
AM/FM TUNER
YCbCr Mode
DVD
YCbCr Mode
AUX IN
CVBS Mode
*CVBS – Composite Video Baseband Signal
Picture Adjustment
To adjust monitor display settings, perform the following steps:
1. Press the
PIC
button on the monitor to display the picture adjustment menu.
The “BRIGHT” bar is highlighted in yellow.
2. Turn the rotary encoder to adjust the brightness setting level.
3. Press the
PIC
button again. The “CONTRAST” bar is highlighted in yellow.
4. Turn the rotary encoder to adjust the contrast setting level.
5. Press the
PIC
button again to exit the picture adjustment menu.
Parking.Brake.Inhibit
When the pink “Parking” wire is connected to the vehicle Parking Brake circuit, the
front TFT monitor will display video when the Parking Brake is engaged. (When
the pink wire is grounded via the Parking Brake circuit, video will be displayed.)
