NAV104 Placement
The NAV104 should be installed under the back or front seat. It can
also be installed in the trunk, if necessary. Do not install the NAV104
where it will come in contact with water or direct sunlight.
To avoid shorts in the electrical system, be sure to disconnect
the negative ( - ) battery cable before beginning installation.
NOTE:
Be sure to install the NAV104 in such a way that the SD Card is
accessible after install, allowing for the removal and insertion of the
SD Card for future changes to map data or upgrades.
Compatible Head Units
• VM9215BT
• VM9225BT
• Select Jensen Multimedia Head Units
Parts List
√ NAV104 navigation module
√ Antenna with magnetic mount
√ Four rubber feet (to affix to the bottom of the NAV104 in the
recessed area near each corner)
√ SmartBus cable (used to connect the NAV104 to the Jensen
navigation-ready radio)
√ One 4 Gigabyte SD Card pre-loaded with map/navigation
software
√ Two 11 mm ( 0.4 in ) screws (for fastening the SmartBus cable
to the radio and NAV104)
Warnings
• Do not install components in areas which are susceptible to
rain, moisture, direct sunlight, extreme heat or cold, excessive
dust, dirt or humidity
• Do not install the NAV104 where it will obstruct the driver’s
view or interfere with the vehicle’s operating system or safety
features (air bags, hazard light buttons, etc.)
• Use only installation parts and hardware provided with the
unit.
• Use of other parts can cause malfunction and possible
damage to your navigation system.
• This product should only be installed in vehicles with a
12 Volt battery with negative grounding. Check the battery
voltage of your vehicle before installation.
• Be sure to secure all wires/cables away from the steering
wheel, shift lever, and gas or brake pedal.
• Do not cut the GPS Antenna Cable to shorten or lengthen it.
128-9088
