17
MP1314
Station Pre-Set Memories
To set any of the 6 pre-set memories in each band, use the following procedure:
1. Turn the radio on and select the desired band.
2. Select the first station to be pre-set using the
button (18) or button (6)
Press for several seconds until
MANUAL
appears on the display, the manual
tuning mode is enabled.
3. Tune to the desired station.
4. Press the pre-set button to be set and continue to hold it in for approximately
2 seconds. The pre-set number, will appear on the display panel below the
frequency indication and a single beep will sound, indicating that the station
is now set into that pre-set memory position. The station can now be recalled
at any time by pressing that button.
5. Repeat the above procedure for the remaining 5 pre-sets on that band and for
the other 3 bands on the unit
RDS Operation
Using PTY to Select Program
• Press the
PTY
button (11) once to enable selection of the PTY program group.
Once a group is displayed, rotate the volume knob (10) to select the desired PTY
program. Once the desired PTY program group is found, press the
button
(18) or the button (6). The unit will search for the associated radio station
and stop when a station is found.
• With PTY enabled, press the
PTY
button (11) again to cancel the PTY function.
Note: When the unit is set to
AREA EUR
in system settings, whenever RDS function
is enabled
AF
will appear on the display. With PTY enabled, press the
PTY
button
(11) again to cancel the PTY function.
Listening to Traffic Announcements
• Press and hold the
EQ
button (16) and the unit will search for traffic
announcements automatically.
TA SEEK
will appear on the display and the
unit will search until the function is disabled. To disable the search for traffic
announcements press and hold the
EQ
button (8).
