![background image](http://html1.mh-extra.com/html/jensen/mcd5060/mcd5060_installation-and-operation-manual_644357007.webp)
MCD5060
7
TUNER OPERATION
Select a Band
Press the
B
button
(19) on the control panel to change between three FM bands and one AM
band. Each band stores up to six preset stations.
Tuning
Auto Seek Tuning
Press the up
>>|
(21) or down
|<<
button (20) on the control panel for less than three seconds
to move to the next station automatically.
Manual Tuning
Press the up
>>|
(21) or down
|<<
button (20) for more than three seconds to enter manual
tuning mode. Press the up
>>|
(21) or down
|<<
button to change the radio frequency number
up or down one step. The radio signal strength meter indicates the strength of the current radio
station broadcast.
Scan
Press the
SC
A
N
button (10) to automatically search for stations. Each available station will flash
on the display for a few seconds before the next is searched. To select a “flashing” station,
press the
SC
A
N
button again.
Local/Distant (LO/DX)
During radio operation, received signals are usually in stereo mode as indicated by the “ST”
icon; however, when the signals are weak or intermittent, you can activate the Local (LOC)
mode by pressing the
LO/DX
button (9) (“LOCAL” appears on the display) on the control panel.
This mode favors access to local stations whose signals are much stronger; thereby improving
radio reception. Press the
LOC
button again to terminate Local receive mode.
Preset Stations
Six numbered preset buttons store and recall stations for each band.
Store a Station
Select a band (if needed), then select a station. Hold a preset button (12-17) for three seconds.
The preset number will appear in the display.
Recall a Station
Select a band (if needed). Press a preset button (12-17) to select the corresponding stored
station.
Automatically Store / Preset Scan (AS/PS)
Automatically Store
Select a band (if needed). Press
AS/PS
(11) on the control panel for more than three seconds
to automatically select six strong stations and store them in the current band. The new stations
replace any stations already stored in that band.
Preset Scan
Select a band (if needed). Press
AS/PS
(11) to scan stations stored in the current band. The
unit will pause for ten seconds at each preset station. Press
AS/PS
again to stop scanning
when the desired station is reached.
Loudness Control (B)
Press the
B
button (19) on the control panel to turn the “Loudness” function on/off. When
Loudness is activated, the display will show “X-Bas” for a few seconds.
Preset Equalizer (PEQ)
Press the
PEQ
button (7) to select from the following preset equalizer functions: FLAT >
CLASSIC > POP M > ROCK > DSP OFF. When “DSP OFF” is selected, the EQ function is
controlled by the Bass/Treble settings.
Stereo
The unit will automatically pick up an FM stereo signal, when available. When in stereo mode,
the “ST” icon appears in the display. When no stereo signal is available, the unit will
automatically revert to mono operation, and no icon will be displayed.
MCD5060
1
2
3
5
6
7
8
9
10
11
20
21
12
13
14 15 16
17
18
19
4
22
Best
Reception
Worst
Reception