E-5
This unit should not be connected to speakers with an impedance of less than 8 ohms, otherwise
damage may result to the unit.
HEADPHONE JACK (PHONES)
This unit will accept stereo headphones (not included) with a 1/8” plug and an impedance of 32 ohms
or greater. The speakers are automatically disconnected when headphones are connected to the
HEADPHONE JACK (2).
TUNER OPERATION
1. Turn on the unit by pressing the POWER BUTTON (3), the POWER INDICATOR (4) lights.
2. Select the desired band (AM/FM/FM ST.) with the FUNCTION SELECTOR (5).
3. Tune in your desired station using the TUNING KNOB (7). If the FM ST. band was chosen, the
FM STEREO INDICATOR (6) will light up whenever a stereo broadcast is received. To receive a
weak (noisy) FM station, select FM band by setting the FUNCTION SELECTOR (5) to the FM
position .The FM STEREO indicator(6) will go off and the reception may be improved, but the
sound is now monaural (MONO).
4. Adjust the VOLUME CONTROL (1) to the desired sound level.
5. To turn the unit off, press the POWER BUTTON (3) again, The POWER INDICATOR (4) goes
off.
HINTS FOR BEST RECEPTION
FM:
The receiver has a built-in FM ANTENNA (8) hanging from the rear cabinet. This wire should
be completely unraveled and extended for best reception.
AM:
This unit is equipped with a built-in directional ferrite antenna. Rotate the unit to obtain the best
reception.
PHONO OPERATION
Note:
Flip-up the clear stylus protector to expose the needle. Be sure that the TONE
ARM is detached from the TONE ARM REST (13) before operating.
1. Turn on the unit with the POWER BUTTON (3). The POWER
INDICATOR (4) will light up.
2. Set the FUNCTION SELECTOR (5) to the PHONO position.
3. Set the SPEED SELECTOR (14) to the proper position depending on the record to be played.
Three speeds (33 rpm, 45 rpm, 78 rpm) can be selected. When 45 rpm is selected, use the 45
rpm ADAPTOR (15).
4. Place the record on the platter (if required, use the 45 rpm adaptor)
5. Lift the TONE ARM (12) from the REST (13) and the platter will begin to rotate as you move it
towards the record.
6. Place the needle of the TONE ARM (12) on the record at the desired position.
7. Adjust the VOLUME CONTROL (1) to the desired sound level.
8. At the end of the record, the platter will continue to rotate until the TONE ARM (12) is returned to
the REST (13).
Note:
The turntable platter will not automatically stop when the record finishes playing. This is to
allow extended play records to play all the way through without prematurely stopping before the
TONE ARM(12) reaches the end of the record (center area).Don't allow the record to continue
turning for extended periods of time once the TONE ARM (12) reaches the center of the record.
This could prematurely wear out the stylus needle.
9. Stop the Turntable by pressing the POWER BUTTON (3). Lift the TONE ARM (12) and return it
to the REST (13).
IMPORTANT:
