E-9
USB CHARGING
THE JEP-175 FEATURES A FRONT MOUNTED USB CHARGING PORT
(DC 5V
1 A) FOR CHARGING YOUR CELL PHONE.
1. Plug the standard end of the USB cable into the USB
PORT (#12) located on the front of
the unit. Plug the other end of the cable into the device you wish to charge.
2. Observe the battery charge indicator on your device to make sure the charging process
starts normally.
3. Unplug the cable when your device is fully charged.
WARNING!
The USB port located on the front of the unit is designed for charging a smart phone or
small portable device and does not support data transfer or connection to a computer
Don’t connect the USB port of the unit to another USB charger. It may damage both units
and void the warranty.
FLASHLIGHT
Press and hold the FLASHLIGHT BUTTON (#6) to turn on the FLASHLIGHT (#8). Press and
hold the FLASHLIGHT BUTTON (#6) again to turn off the FLASHLIGHT (#8).
CARE AND MAINTENANCE
1. Do not subject the unit to excessive force, shock, dust or extreme temperature.
2. Do not tamper the internal components of the unit.
3. Clean your unit with a dry cloth. Solvent or detergent should never be used.
4. Avoid leaving your unit in direct sunlight or in hot, humid or dusty places.
5. Keep your unit away from heating appliances and sources of electrical noise such as
fluorescent lamps or motors.
TROUBLE SHOOTING GUIDE
If you experience difficulties in the use of this clock radio, please check the following or call 1-
800-777-5331 for Customer Service and support
Symptom
Possible Cause
Solution
Noise or sound
distorted on FM
broadcast
- Station not tuned properly for
FM.
- The antenna is not positioned
correctly
- Retune the FM broadcast station.
- Fully extend the telescopic antenna
or reposition the unit until the best
reception is obtained.
FM no sound
- Unit not in “RADIO” function
mode.
- Volume set at minimum
- Tap the MODE BUTTON to select
FM mode.
- Increase Volume.
Sound appears
distorted at high
volume setting
- Volume control is set to
maximum.
- Adjust Volume control to a lower
comfortable level.
No charging from the
USB port
- The USB cable is damaged or
not securely attached
- Replace the USB cable or try
reconnecting it again
