E-6
SETTING THE CALENDAR AND CLOCK
Note: The radio and AUX must be OFF to set TIME/DATE. To turn off, press and hold the SOURCE (#1)
button for 2 seconds. The time will then be displayed.
IMPORTANT: Digits will flash during setup and time-out after 5 seconds if no buttons are
pressed.
1. Press and hold PRESET (#2) for 2 seconds to enter calendar/time setting mode.
2. Setting the clock for the first time, the number 15 will flash on the display.
This represents the last 2 digits of the year.
3. Press (#3) or TUNING- (#4) to increase or decrease the YEAR.
Note: If display reverts back to time, press and hold PRESET for 2 seconds to re-enter the
programming mode.
4. Press PRESET (#2), and the MONTH will flash.
5. Press (#3) or TUNING-(#4) to increase or decrease the MONTH.
6. Press PRESET (#2), and the DAY will flash.
7. Press (#3) or TUNING-(#4) to increase or decrease the DAY.
8. Press PRESET (#2) and time will flash.
9. Press (#3) to set the MINUTES.
10. Press TUNING-(#4) to set the HOUR.
11. Press PRESET (#2) to complete the calendar/time setting.
SETTING UP THE TIME ZONE
There are 7 time zones programmed into your unit:
Zone 1: Atlantic Std Time ,UTC- 4 hrs
Zone 2: Eastern Std Time ,UTC- 5 hrs (factory preset)
Zone 3: Central Std Time, UTC- 6 hrs
Zone 4: Mountain Std Time, UTC- 7 hrs
Zone 5: Pacific Std Time, UTC- 8 hrs
Zone 6: Alaska Std Time, UTC- 9 hrs
Zone 7: Hawaii - Aleutian Std Time, UTC- 10 hrs
1. In standby mode, press and hold the TIME ZONE BUTTON (#9) until the current time zone number
shown on the LED DISPLAY #10.
2. Repeat the above step until the time zone number, 1-7 as shown above that corresponds to your
area.
3. The Time Zone will be stored after 5 seconds.
Note
: Above time zones are not covering Alaska and Hawaii. If you plan to use this model in these
zones, you can still manually set the time regardless what position of time zone switch is. However,
time zones program above will not match the list under such setting.
DST - DAYLIGHT SAVING TIME
The DST function allows you to add one hour to the current time (in Spring) and subtract an hour from
the current time (in Fall), if DST is observed in your area.
Press and hold DST BUTTON (#7) 2 seconds at standby mode to turn on the DST function. The DST
LED indicator will light on the bottom left corner of the LED DISPLAY (#10).
Press and hold DST BUTTON (#7) 2 seconds again at standby mode to turn off the DST function. The
DST LED indicator will turn off.
