6
LISTENING TO THE RADIO
1. Set the BAND SELECTOR to the desired band, AM or FM.
2. Slide the FUNCTION SELECTOR to the “ON” position.
3. Select your desired station with the TUNING CONTROL.
4. Adjust the VOLUME CONTROL to the desired listening level.
5. When you have finished listening, slide the FUNCTION SELECTOR to the “OFF”
position to turn the radio off.
TIPS FOR BEST RADIO RECEPTION
AM - The AM antenna is built inside the radio. If AM reception is weak, change the
position of the unit until the internal antenna picks up the strongest signal.
FM - If FM reception is weak, fully extend the wire antenna and vary the position
and location of the antenna until you find the strongest signal.
AUX IN OPERATION
This unit features an aux line-in jack for connecting your iPod, MP3 player or other
digital music player.
1. Connect the headphone jack of your external device to the AUX IN jack located on
the back of the JCR-175 (cable not included).
2. Turn on the JCR-175 and it will enter the AUX function mode once an external
device is plugged into the AUX IN jack.
3. Start playing your iPod, MP3 player or other external audio device.
4. Slowly adjust both volume controls on the JCR-175 and the external device.
5. Turn off your iPod, MP3 player etc. when finish listening. Turn the JCR-175 off and
unplug the AUX IN jack.
Remark:
Once the AUX IN jack is plugged during POWER ON mode, it will
automatically enter the AUX mode no matter what position the Band Selector is in.
Remember to disconnect the cable from JCR-175 after use in order to be able to listen
to the radio again.
ALARM OPERATION
SETTING THE WAKE UP TIME
1. Press and hold the ALARM BUTTON and repeatedly press the HOUR BUTTON to
set the correct wake up Hour.
2. Press and hold the ALARM BUTTON and repeatedly press the MINUTE BUTTON
to set the correct wake up Minute.
NOTE
There is a PM INDICATOR located in the top left-hand corner of the clock display. Be
sure to observe the PM indicator when setting the alarm to make sure the alarm time is
set correctly for AM or PM. If the PM indicator is 'On', the alarm time will be "PM". If not,
the alarm time will be "AM".
CHECKING THE WAKE UP TIME
