JCD3007
7
TUNER OPERATION
Select a Band
Press the BAND button
(21) on the control panel to change between three FM bands and
one AM band. Each band stores up to six preset stations.
Tuning
Auto Seek Tuning
Press the TUNE Up button (19) or TUNE Down button (18) on the control panel for less than
three seconds to move to the next station automatically.
Manual Tuning
Press the TUNE Up button (19) or TUNE Down button (18) for more than three seconds to enter
manual
(19) or TUNE Down button(18) to change the radio
tuning mode. Press the TUNE Up
frequency number up or down one step. The radio signal strength meter indicates the strength of
the current radio station broadcast.
Scan
Press the
SCAN
button (22) to automatically search for stations. Each available station will flash
on the display for a few seconds before the next is searched. To select a “flashing” station,
press the
SCAN
button again.
Preset Stations
Six numbered preset buttons store and recall stations for each band.
Store a Station
Select a band (if needed), then select a station. Hold a preset button (9-14) for three seconds.
The preset number will appear in the display.
Recall a Station
Select a band (if needed). Press a preset button (9-14) to select the corresponding stored
station.
Automatically Store / Preset Scan (AS/PS)
Automatically Store
Select a band (if needed). Press
AS/PS
(16) on the control panel for more than three seconds
to automatically select six strong stations and store them in the current band. The new stations
replace any stations already stored in that band.
Preset Scan
Select a band (if needed). Press
AS/PS
(16) to scan stations stored in the current band. The
unit will pause for ten seconds at each preset station. Press
AS/PS
again to stop scanning
when the desired station is reached.
Preset Equalizer (EQ)
Press the
EQ
button (15) to select from the following preset equalizer functions: FLAT >
CLASSIC > POP M > ROCK > DSP OFF. When “DSP OFF” is selected, the EQ function is
controlled by the Bass/Treble settings.
Stereo
The unit will automatically pick up an FM stereo signal, when available. When in stereo mode,
the “ST” icon appears in the display. When no stereo signal is available, the unit will
automatically revert to mono operation, and no icon will be displayed.
Best
Reception
Worst
Reception
1
4
6
5
2
3
8
10
16
9
11
12
13
14
21
15
20
19
18
7
22
17
R
WE
PO
AUX
SCN
RPT
SHF
AS/PS
EQ
SCAN
M
U
TE
VOLUME
VOLUME
MODE
B
N
A
D
AUDIO
JCD3007
40
WATTS x 4
U
LO
D
