Your JENSEN EHT-909
is an
extremely powerful Active Subwoofer powered
by an on-board 280 Watt RMS amplifier. Twin 10”
heavy duty “monster” drivers – one down-firing and
one rear-firing will spread Bass throughout your room.
Floor Positioning:
Best room location is in,
or across a corner. Bass response can vary slightly as Subwoofer
frequencies are mainly non-directional, and room acoustics may differ from one corner to the
next. Therefore we suggest trying two or three locations before settling on a permanent location.
This location of course, will need a Power Point.
Subwoofer amplifier features.
LEDs
on front panel are Purple when active and Red when on standby. Standby mode, like on
a TV draws next to no power.
OFF/AUTO/ON switch:
Leaving your EHT-909
ON
permanently will remain ON and
continue to draw power and purple LEDs will continue to glow.
Switch to
OFF
when not using for long periods or when on
holidays (RED LEDs). We recommend switching to
AUTO
permanently
so your EHT-909 will activate automatically when
incoming signal is received (PURPLE) then revert to standby
(RED) when signal is ceased. When powering down, it is not
uncommon to take between 15 and 40 minutes for LEDs to revert to RED from PURPLE.
AUTO
can be left on indefinitely.
PHASE Switch:
Once your entire speaker system is completely set-up, flick this switch
from “0” to “180” and leave on setting that provides the most
Bass. Leave switch on “0” if no audible increase is detected.
If running multiple EHT-909’s, ensure all are set to same position.
This will ensure all woofers are operating together in the same room
so that Bass cancellation does not occur.
FREQUENCY Knob:
This adjusts how low (in frequency terms) you wish your EHT-909
to operate at. In other words, 40 Hz is a way lower and deeper frequency than 100Hz. So if you
set at say, 70Hz you will be amplifying all music
70Hz and below
and filtering out everything
above which is the correct intention of a Powered Subwoofer. Take care not to advance this
control too far as overloading may occur (see below setting recommendations).
EHT-909
.
.
OFF
AUTO
ON
PHASE
0
0
0
180
